How to Install Your Environmental Water Systems EWS F.SET.SS-2.5 Replacement Filter Cartridge

Introduction

A bright spot about the Environmental Water Systems Essential Max Flow Replacement Filter, EWS F.SET.SS-2.5, is the ease of installation. 

Usually after around one year, it is best practice to purchase a replacement and change the water filter, from your Environmental Water Systems - SS-2.5 Essential Max Flow in-line Filter System. 

If you are wanting to purchase a system, or need help installing the Environmental Water Systems - SS-2.5 Essential Max Flow in-line Filter system, please go here, as this blog is meant for replacing the replacement cartridge filter. 

No Plumber Needed DIY

1.) Close inlet water supply shut-off valve to the system.

2.) Open cold side of your faucet (and if applicable, allow other device(s) to flow).

Allow water to flow. Water should stop in a short time. Keep open to relieve pressure. CAUTION: WATER WILL BE PRESENT WHEN FILTER IS CHANGED. A pan, towel, etc. should be placed under the system to catch any water.

3.) Unlock and remove old filter cartridge.

4.) Insert and lock new filter cartridge into filter head. See #2 in the complete instructions

5.)  Turn on the water and start up properly. See # 17 in the complete instructions to open the supply shut-off valve to the system.

6.)  FLUSH, ENJOY and SET A REMINDER See #’s 18, 19, 20 in the complete instructions to flush the new filter and to start up system properly Step

7.) Follow inspection procedure

Conclusion

The process of replacing your Environmental Water Systems Essential Max Flow Replacement Filter, EWS F.SET.SS-2.5  is very easy.  Just follow the steps above. 

If you need help with anything, please do not hesitate to contact us here, or on our email Support@DrinkingWellCo.com.